Plugin - rF2 Motec

Por favor, indica en el titulo si se trata de : [Mod] [Circuito] [Plugin] [Manual]

Moderador: XRStaff

Responder
Avatar de Usuario
crobol
Maestro al volante
Maestro al volante
Donante
Donante
Licencia B
Licencia B
Mensajes: 13867
Registrado: 28 Abr 2007 00:00
Volante: DFP
Ubicación: BCN
Contactar:

Plugin - rF2 Motec

Mensaje por crobol » 06 Feb 2012 06:09

Imagen
Motec PlugIn V1.0

Fixes :
  • -Previous version wasn’t deleting its temp files – sorry!
    -(you can go and delete any .ldtemp files you find in your log folder, MoteC doesn’t use them)
Changes :
  • -Added most of the new data in rF2′s plugin interface, but there are some caveats:
    -Filtered input can now be logged. You can see autoblip & autolift, speed limiter, and probably also TC on the throttle trace, ABS effects will be seen on braking (I think!), steering input is affected by steering help and maybe sensitivity etc. I’m not sure how useful this is so you can choose in the .ini file whether to log the raw inputs as before, the new filtered ones (which will appear as the normal input channels in MoteC), or both (Filtered inputs are new channels, and you’ll have to add them to graphs yourself).
    -Wheel Toe and Camber is logged – unfortunately rF2 is currently returning 0 for all camber values.
    -Steering input is now a percentage of full lock. In rF1 I was grabbing the current setup steering lock from memory and producing a steered angle from it, but you should be able to use the average of FL and FR Toe values to get an accurate steered angle figure (MoteC’s built-in ‘Oversteer’ Maths will use it).
    -Aerodynamics figures (drag, front/rear downforce, front wing height, front/rear height) can be logged, but again this is optional and off by default. I’ve assumed N for the forces.
    -Contact patch details are referenced and now logged (lateral and longitudinal velocities for both the ground at the contact patch and the contact patch itself)… but always return 0 from rF2. Even if it worked I would wonder how useful it would be for setting up a car, but if it ever gets switched on you can log it if you want.
    -‘Brake Pressure’ for each wheel; the files (ISI) say this is a percentage figure at the moment, so they will represent the current brake balance and pedal position. Expected to switch to kPa later on, I’ll update the unit then.
    -Other new channels: Suspension force for each wheel, front and rear third spring deflection.
Downloads:
http://www.gamefront.com/files/21205342 ... 012012.rar (gamefront)
http://www.mediafire.com/?yxzolumc9tudlrx (mediafire)
Avatar de Usuario
Regok
Calentando neumaticos
Calentando neumaticos
Donante
Donante
Licencia A
Licencia A
Mensajes: 169
Registrado: 26 Feb 2011 23:12
Volante: g27 racing wheel

Re: Plugin - rF2 Motec

Mensaje por Regok » 15 Abr 2015 19:33

Hola buenas!

Estoy intentando bajarme el plugin pero un enlace esta roto y el otro me pide contraseña, alguien sabe otro enlace o una version del pluguin nueva que me pueda descargar?

Gracias y saludos,
"If you no longer go for a gap that exists you no longer are a racing driver" Ayrton Senna

Imagen
Responder